How to remove front and rear bumper Chrysler Sebring (2000-2006)

Chrysler Sebring II ST-22/JR (2000-2006)

Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-under the hood take out the five rivets (inserted from top to bottom) that secure the upper part.

-take out the caps (inserted from the bottom up) around the perimeter at the bottom.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-in the wheel wells, unscrew the screws and peel the fender liner.

-for wheel arch liners unscrew one screw on each side that attach the angles to the wings.

-with the assistant pulls the bumper from the guides themselves.

-remove the connectors from the equipment (if any).

Rear bumper

⇒Tips for removing bumpers and how to avoid breaking anything..⇐

-wheel arches unscrew the screws that attach the fender liner.

-the fender liner, unscrew the screws holding the corners of the bumper to the wings (spun up).

-in the opening of the trunk and pull out the caps (inserted upside down).

-in the boot remove the side trim (you need to access the rear part of the rear lights).

-for sheathing, below the rear lights, Unscrew the nuts (depending on year of issue on one or two on each side) holding the bumper to the wings.

-from under the car unscrew the screws that attach the bottom part (may not be).

-with the assistant gently pulls the bumper itself from the guides.

-remove the connectors from the equipment (if any).

How to remove front and rear bumper Chrysler Sebring (1994-2000)

How to remove front and rear bumper Chrysler Sebring (2006-2010)