-
-
-
SEAT Toledo III (2004-2009)
Front bumper
Depending on the version of the model the attachment is different.
-under the hood, Unscrew the four screws (spun down).
-in the Central decorative lattice Unscrew one screw on each side (in the models since the end of 2006, these screws are not).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-wheel arches Unscrew the screws that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side in the corners.
-Unscrew the eight screws at the bottom (spun up).
-with the aide of tear corners with latches and pulls the bumper from the guides themselves.
-remove connector from the PDC (if any).
-remove the connector from the fog lamp.
-if you have headlight washers, disconnected the hoses. The liquid leaking on the ground, you need to prepare a suitable container.
Rear bumper
Depending on the version of the attachment may vary.
-in the side panels remove the cap.
-under plugs Unscrew the retaining knobs and remove the tail lights.
-under the rear lights Unscrew two screws on each side.
-Unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).
-move the wing flaps to the side and Unscrew one screw on each side (spun up).
-Unscrew the screws around the perimeter in the bottom (spun up).
-with the aide of tear corners with latches and pulls the bumper from the guides themselves.
-remove the electrical connector license plate light.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español