-
-
-
Front bumper
Removed the bumper without grille.
-wrenched the wheel, depending on which side we understand.
-wheel arches and drilled the two rivets.
-is released from the latch in the bumper pads of the wings (pull over), fully lining can not be removed.
-wheel arches Unscrew one screw on each side that attach the angles to the wings and take out one striker (need rotate 90 degree).
-perimeter of the lower part and pull out the caps.
-we release the latch in the wings (pull the corners over), under the headlights and under the grille.
-with the assistant pulls the bumper forward (pay attention to wire).
-remove the connectors from the equipment (if any).
Rear bumper
-open the trunk lid.
-Unscrew the two screws in the opening of the trunk.
-wheel arches take out the caps and Unscrew the screws that attach the fender liner and trim the fenders to bumper.
-is released from the latch (pull to yourself) and remove the lining of the wings (might have to drill out rivets).
-over plates of wings Unscrew one screw on each side.
-around the bottom part Unscrew the screws (depending on year, the number of changes).
-we release the latch in the wings (pull the corners themselves).
-with the assistant pulls the back bumper (don't want to break the wires).
-snap together the connectors of electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español