Infiniti JX35 / QX60 (2013-2020) bumper removal.

Depending on the year of manufacture, the mounting locations may vary slightly.

Front bumper

-open the hood.

-under the hood, take out the sixteen pistons (inserted from top to bottom) and remove the trim above the top of the front bumper.

-move aside the rubber pads above the headlights and unscrew one screw on each side that secure the bumper to the wings, take out the plastic clips.

-from the bottom, unscrew three screws on each side that secure the fender liners and take out the six pistons that secure the engine compartment protection.

-turn the wheels to the side.

-in the wheel arches, unscrew three screws on each side and release the fender liners (front part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches under the headlights.

-with an assistant, carefully pull the bumper forward (watch the wires and hoses).

-remove the connectors of the electrical equipment.

-if there are headlight washers, disconnect the hoses (liquid may leak).

Rear bumper

-open the trunk lid.

-in the trunk opening, release it from the latches and remove the trim near the rear lights.

-behind the trims, unscrew two screws on each side, release them from the clamps and remove the rear lights.

-under the rear lights, take out the two pistons and Unscrew the two screws.

-from the bottom, unscrew the four screws and take out the two pistons that secure the lower part.

-in the wheel arches, unscrew the screws that secure the mudguards and release the fender liners (rear part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches in the trunk opening.

-with an assistant, pull the bumper back (watch the wires).

-disconnect the connectors of the electrical equipment.