Infiniti QX50 I (2013-2017) bumper removal.

Depending on the year of manufacture, the mounting locations may vary slightly.

Front bumper

-open the hood.

-under the hood we take out the eight pistons (inserted from top to bottom) that secure the radiator grille and the upper part of the front bumper.

-from the bottom side, unscrew the twelve screws (twisted from bottom to top) that secure the lower part.

-turn the wheels to the side.

-in the wheel arches, unscrew two screws on each side and release the arch linings from the bumper (they are held on by latches, we pull them towards us from the bottom up).

-take out the pistons and release the fender liners (front part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches under the headlights (pull towards yourself).

-with an assistant, carefully pull the bumper forward (watch the wires).

-we release the connectors of the fog lights and other electrical equipment (if any).

Rear bumper

-open the trunk lid.

-in the trunk opening, remove two trims (held on by latches).

-under the trims, unscrew the four screws that secure the rear lights and the four screws that secure the upper part of the rear bumper.

-release it from the clips in the wings and remove the rear lights.

-under the rear lights we take out two pistons.

-from the bottom, unscrew the four screws and take out the two pistons.

-we release the arch linings from the bumper (they are held on by latches, we pull them towards us from the bottom up).

-release the fender liners (rear part).

-move the fender liners to the side and Unscrew one screw on each side that secures the corners to the wings.

-release the latches in the wings (pull the corners of the bumper towards you).

-with an assistant, pull the bumper back (make sure not to break the wires).

-disconnect the connectors of the electrical equipment (if any).