-
-
-
Front bumper
-open the hood and Unscrew the three screws (twisted upside down) holding the bumper and grille to the top of the bar.
-take out the rivets that attach the lower part (inserted from the bottom up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-wheel arches Unscrew the screws that attach the fender liner.
-pushed aside and wrenched the wheel arches on each side one screw (spun up), which attach the angles to the wings.
-remove the turn indicators (mounted on the latches).
-under direction indicators free the clips.
-with the aide of tear clips in the wings and pulls the bumper from the guides themselves.
-remove connector from the PDC (if any).
-remove the connector from the fog lamp (if any).
Rear bumper
Depending on the model year and model type, the attachment is different.
-open the boot lid and twisted in the opening four screws (spun up).
-Unscrew the aperture for one screw on each side near the rear lights.
-in the boot remove the side trim (you need to access the rear part of the rear lights).
-in the wings Unscrew three nuts on each side (will need head ratchet).
-in the wheel wells, Unscrew the screws holding the fender liner (if any).
-move the wing flaps to the side and take out one piston on each side that attach the angles to the wings (can not be).
-take out the caps on the perimeter in the lower part (inserted from the bottom up).
-with the assistant pulls off the guides themselves.
-if you have sensors, remove the connector.
English 
Italiano 
Français 
русский 
Deutsch 
Español