-
-
-
Depending on the model year and model type, the attachment may vary.
Front bumper
-open the hood and Unscrew the screws and take out the caps (inserted and twisted from the top down), remove the air intake.
-under the hood, Unscrew the screws and take out the clips that secure the grille.
-release the screen from the latches and remove.
-under the grille and pull out the piston.
-around the bottom part Unscrew the screws (spun up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-in the wheel arches to turn out screws and take out the clips holding the fender liner.
-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).
Rear bumper
-open the boot lid and twisted in the opening one screw on each side.
-on the perimeter in the bottom part Unscrew the screws and remove clips (twisted and inserted from the bottom up).
-Unscrew the screws in the wheel arches that secure the fender liner.
-assistant free the bumper from the clips in the wings and under the tail lamps.
-pulls from the guides themselves.
-remove connector from the PDC (if any).
-remove connectors with additional equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español