-
-
-
Depending on the model year and model type, the attachment is different.
Front bumper
-under the hood, Unscrew the two screws and take out the piston (twisted and inserted top to bottom) that secure the grille.
-we release the latch in the bumper and remove the grille.
-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-wheel arches Unscrew the screws that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.
-assistant exempt corners of the latches and remove the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove connector from parkonika (if any).
-if you have headlight washers, disconnected the hoses.
Rear bumper
-in the trunk, Unscrew the screws and remove the back and side plating.
-for casings, Unscrew the four nuts (need head ratchet), one near the rear lights and two in the rear.
-wheel arches take out the rivets that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.
-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).
-assistant free the bumper from the clips in the wings and pulled off of the guide itself.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español